Burner control

On-site housing, for controlling, igniting and Monitoring pulse-controlled, Modulating or stepped regulated gas burners. For continuous operation with ionization monitoring Or UV monitoring with UV probe UVD. Intermittent operation With UV probe UVS. Display of the program status, The device parameters and the Flame signals. Manual operation mode. Diagnosis and setting of the device parameters Via optical interface and PC software BCSoft. EC type-examination And certified, FM and CSA approved, AGA approved (BCU 440, 460 and 480), Certified for systems up to SIL 3 (Corresponds to PL e). Device type Part1 BCU Type of device BCU 460 speak air control air control speak Mains voltage 230VAC-50 / 60Hz Ignition transformer TZI 7,5-20 / 33 Front inscription front GB, sticker D, F, I, NL, E Industrial connector 16-pin Without High temperature operation Without UVD / signal distribution Without Fieldbus Interface, Type None Power supply Via phase L1 Packaging units Individual packaging Customized Option Without Rewiring single electrodes 2 electrodes 04 Switch-off threshold burner 1 1 μA 35 UVS inspection 0 15 extraneous light. Standby 21 Minimum burner pause time 0 p 22 Safety time Burner 1 5 S 10 Start - up of burner 1 2 14 Safety time during operation 1 p 23 Fl. - Stabilization time 1 0 S 20 Minimum burning time 0 S 12 Re-start burner 1 off 34 Burning time in manual mode limited to 5 min. 30 Air valve opens with valve V1 31 Air valve during start-up 36 Low-load after-run time 0 S 32 Air valve can be activated externally in the event of a fault