Deutsch
English
Produktanfrage senden
The equipment includes two parts
| Hinweis | 100W @ 220V, 50 HZ |
|---|---|
| Light source | LED technology |
| Minimum hole size | 5 mm at 1200 m/sec |
| Detection response | 5 msec |
| Gap between TX & RX | Up to 2 meters (max. 3 m) |
| Optical Alignment | Through monitor led |
| Width detection | 350 mm |
| Ambient light immunity | Frequency modulation |
| Output by relay Max | 250 Vac 5 A |
| Output by optocoupled Max | 70V, 50 mA |
| Signal output length | Adjust. (40 to 200ms) |
| Dimensions (WxHxD) | 395 x 65 x 104 mm |
| Ambient Temperature | From -5 to + 55 °C |
| Weight | Approx. 7500 g |
| Protection | IP 54 |
| Supply | Single phase |
POWER SUPPLY
| Transmitter (HDT) | 100-240V.a.c 50/60Hz 40VA |
|---|---|
| Receiver (HDR) | internal supply by transmitter |
Relay
| Contact N.A. | Pin A ; Pin B (CN2) |
|---|---|
| Contact N.C. | Pin A ; Pin C (CN2) |
Optocoupler
| Contact N.C. | Pin D ; Pin E (CN2) (Open when there is the hole) |
|---|---|
| Output connector | CN2 Connector DDK (typo DMS3102A14S-5S) |
| Hinweis | The signal is real time monitoring when the hole is passing on the inspection line. |
| Led Hole Alarm | On when there is the hole |
| Led Run | Monitoring the CPU system working |
| Led Alignment | Use to make alignment |
Review product
No review available for this product.