Bascule wedge loading bridge HÖRMANN HLS-2 as P-model (pit model)

Self-supporting steel-joint construction with electro-hydraulic unit, according to the valid regulations such as DIN EN 1398. For welding at the rear and front, with angle 100 mm at the rear. Dimensions: Order width: 2,000 mm Order length: 2.500 mm Pit width: 2.025 mm Pit length: 2,570 mm Height: 595 mm Folding wedge: 395 mm Load capacity: Nominal load according to EN 1398 120 kN as standard. Height compensation (depending on order length): Level compensation above OFF: + 290 mm Level compensation below OFF: - 290 mm According to DIN EN 1398 and BGR 233, a maximum slope of 12.5% (approx. 7°) is permissible. Construction: Torsion-resistant loading bridge construction with 2-cylinder technology, platform made of profiled, anti-slip steel, 8/10 mm thick, with folding wedge made of profiled, anti-slip steel, 12/14 mm thick, 395 mm long, with open, self-cleaning folding wedge hinge. Folding wedge type R (up to 2,000 mm width standard), straight. Reinforcing profiles on underside of platform Surface: All steel surfaces are sandblasted or pickled and galvanised. Drive: With electro-hydraulic drive, motor power 1.1 kW, supply voltage 400 V, protection class IP 54. Control 420 S: Shielded control housing, protection class IP 65, supply voltage 400 V, with integrated membrane push-button for actuation with continuous pressure. Emergency stop switch (all-pole disconnection). Restart interlock. Temperature range: Standard version suitable for temperature range (under the loading bridge) from approx. -10 to +40°C. Special oil required for colder and warmer temperatures. required. Incl. gap seal